If so, have you shipped directly to Callaway in Carlsbad or must use a retailer to ship for you. We’d love to have you! Hope this helps, Ray. Hoping I don’t need to get into any shimming headaches. Next lightly roughen the shaft tip. Has you thinking you know what flex you need?
|Date Added:||22 March 2011|
|File Size:||46.49 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
The folks who are saying it is a Christmas movie appear to be doing it tongue-and-cheek for the most part. I’ve reshafted clubs sitting at my desk in my office with a minimum of tools.
Looks like New Kent and Stonehouse have new owners and will reopen in I recently ordered a set of MacGregor Pro M irons with Nippon shafts and I’ve had some experience with them in the past but not extensive. This provides an extra cushion around the shaft. Since so many woods now have graphite in them originally, and more and more are made of titanium, I have virtually abandoned the use of a torch in favor of an electric heat gun.
Once the plug and ferrule have set, abrade the tip as usual and epoxy the shaft into position and carefully line up the shaft graphics. Once the shaft is removed, make sure to remove any remnants of the ferrule, particularly in the groove at the top of the head. He can be reached in the shop at or MWeidel aol. The issue is, they have A-flex graphite shafts. The concern I had was that he said they basically scrap the old shafts, but I was really hoping I could get them back to offset the cost of the new shafts.
This would include the following:. Register a new account. Project X shafts are expensive, yet if you order them off of the internet as a badge of honor? This would include the following: While like any other installation you want a light film of epoxy czllaway the shaft, make sure there is a sufficient amount to fill the channel at the top of the club head and under the ferrule.
Prev 1 2 3 Next Page 1 of 3. Use a hack saw to roughly cut off the protruding shaft, but don’t worry about taking it down too close. If you have any polishing marks from the Scotchbrite wheel, they can be blended in with some wax on an unstitched wheel. Im not saying that I think everyone should do it but I was taught golf by a pretty oldschool guy a former combat medic during WW2 to be exact and Ive always liked the practice.
Then you get to keep the shafts, and you have it in writing which grip to put on. Posted August 18, Community Forum Software by IP. Hope this helps, Ray. If the customer goes for it, the shorty ferrule is the better choice.
The popup will be closed in 10 seconds Ping G LST 8. Am I missing anything from my shopping list?
Callaway Reshaft Experience
Additionally, are there any issues resifting a graphite model with steel? When your Bertha is reshafted and the epoxy set, take a few strips of heavy duty duct tape and put it on the sole around the bore thru. Use a hosel cleaning brush or file though the inside hosel area and finish up by running a paper towel with acetone through the head to clean out any residue.
I reshacting love to reshaft reshaftin irons in steel and put them in my bag.
Callaway Big Bertha Reshafting
Great experience and customer service. Callaway FT-3 Tour 9. Having said that, Callaway bore-through reshafts are not the troublesome things they once were.